TM 9-2320-387-24-l
1 5-l 7. SPEEDOMETER DRIVEN GEAR REPLACEMENT
I
Tbii task covers:
a. Removal
INITIAL SETUP:
b. Installation
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Special Tools
Materials/Parts
O-ring seal (Appendix G, Item 284)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Mirror, inspection (Appendix B, Item 84)
Maintenance
Level
Unit
p7iGz-l
1.
Disconnect flex driveshaft (1) from correction adapter (2).
2.
Loosen nut (3) and remove correction adapter (2) from pinion adapter (6).
3.
Remove capscrew (4) and clamp (5) from pinion adapter (61 and transfer case (8).
4.
Pull pinion adapter (6) out of transfer case (8).
5.
Remove O-ring seal (7) from pinion adapter (6). Discard O-ring seal (7).
6.
Remove driven gear (9) from transfer case (8).
b. Installation
1.
Install O-ring seal (7) on pinion adapter (6).
NOTE
Note number stamped on driven gear.
2.
Install driven gear (9) into pinion adapter (6).
NOTE
Numbers on pinion adapter represent numbers stamped on driven
gear. When installing adapter, numbers on adapter must match
numbers on transfer case housing.
3.
Install and align pinion adapter (6) into transfer case (8) with clamp (5) and capscrew (4). Tighten
capscrew (4) to 15 lb-R (20 Nem).
4.
Install correction adapter (2) on pinion adapter (6) and tighten nut (3).
5.
Connect flex driveshaft (1) to correction adapter (2).
5-34