TM 9-2320-387-24-14-20Change 1Section II. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE4-9. STARTER AND STARTING CONTROL SYSTEM MAINTENANCE TASK SUMMARYTASKPAGEPARA.PROCEDURESNO.4-10.Rotary Switch Replacement4-204-11.Starter Replacement4-224-12.Circuit Breaker Replacement4-26ManualReferencesTM 9-2320-387-10TM 9-2320-387-24PEquipmentConditionBattery ground cables disconnected (para. 4-68).MaintenanceLevelUnita. Removal1.Remove screw (8), lockwasher (7), and switch lever (6) from switch shaft (9). Discard lockwasher (7).2.Remove nut (5) and lockwasher (4) from switch (2) and instrument panel (3). Discard lockwasher (4).3.Push switch (2) out of hole in panel (3).4.Disconnect three electrical leads 11A (1), 14A (10), and 29A (11) from switch (2).b. Installation1.Connect three electrical leads 11A (1), 14A (10), and 29A (11) to switch (2).2.Install switch (2) into hole in instrument panel (3).3.Install lockwasher (4) and nut (5) on switch (2).4.Place switch lever (6) on switch shaft (9) to ENGINE STOP position.5.Secure lever (6) on switch shaft (9) with lockwasher (7) and screw (8).NOTEPrior to removal, tag leads and note position of lever for installation.INITIAL SETUP:ToolsGeneral mechanic’s tool kit:automotive (Appendix B, Item 1)Materials/PartsLockwasher (Appendix G, Item 208)Lockwasher (Appendix G, Item 207)This task covers:a. Removalb. Installation4-10. ROTARY SWITCH REPLACEMENT
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
