TM 9-2320-387-24-l
-
CHAPTER 2
SERVICE AND TROUBLESHOOTING (UNIT) INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT,
DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
1 2-l.
COMMON TOOLS AND EQUIPMENT
1
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
1 2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
1
Special Tools, Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment used to
maintain the vehicles covered in this manual can be found in TM S-2320.387-24P. Calibrate all measuring
and test equipment used to determine equipment conformance in accordance with TB 43-1800.
2-3. FABRICATED TOOLS
Fabricated tools needed to maintain the equipment in this manual can be found in appendix D. These tools
are not available for issue, but must be fabricated and applied by unit, direct, and general support personnel
only.
2-4. REPAIR PARTS
Repair parts are listed and illustrated in TM S-2320-387.24P.
Section II. SERVICE UPON RECEIPT
a. Upon receipt of a new, used, or reconditioned vehicle, you must determine if the vehicle has been
properly prepared for service. The following steps should be followed:
(1) Inspect all assemblies, subassemblies, and accessories to ensure they are in proper working order.
(2) Secure, clean, lubricate, or adjust as needed.
(3) Check all basic issue items (TM 9-2320-387-10) to ensure every item is present, in good condition,
and properly mounted or stowed.
(4) Follow general procedures for all services and inspections given in TM 9-2320-387-10.
b.
The operator will assist when performing service upon receipt inspections.
c. See TM S-2320-387-10 when checking equipment for proper operation.
d.
Refer to TM S-2320-387-10 for information concerning break-in procedures.
2-l
