3-19. AIR INTAKE ASSEMBLY AND BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
a. Removal
1.
Remove locknut (5), washer (3), capscrew (2), and washer (3) from air intake assembly (1) and
support bracket (4). Discard locknut (5).
2.
Loosen two clamps (6), and remove air intake assembly (1) and rubber boot (6.1) from air cleaner
extension (7).
NOTE
Perform steps 3 and 4 for M1114 and step 5 for M1113.
3.
Remove two locknuts (11), capscrews (8), washers (9), and support bracket (4) from mounting
bracket (10). Discard locknuts (11).
4.
Remove two capscrews (14), washers (13), and mounting bracket (10) from windshield (12).
5.
Remove two capscrews (16), washers (15), and support bracket (4) from windshield (12).
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Three locknuts (Appendix G, Item 114)
Manual References
TM 9-2320-387-24P
Equipment Condition
Weathercap removed (para. 3-18).
b. Installation
NOTE
Perform step 1 for M1113 and steps 2 and 3 for M1114.
1.
Install support bracket (4) on windshield (12) with two washers (15) and capscrews (16).
2.
Install mounting bracket (10) on windshield (12) with two washers (13) and capscrews (14).
Tighten capscrews (14) to 6 lb-ft (8 N•m).
3.
Install support bracket (4) on mounting bracket (10) with two washers (9), capscrews (8), and
locknuts (11).
4.
Install rubber boot (6.1) and air intake assembly (1) on air cleaner extension (7) with two clamps
(6). Tighten clamps (6) to 50-60 lb-in. (6-7 N•m).
5.
Install air intake assembly (1) on support bracket (4) with washer (3), capscrew (2), washer (3), and
locknut (5). Tighten capscrew (2) to 43 lb-ft (58 N•m).
TM 9-2320-387-24-1
3-34
Change 1
