0 II
. .
WARNING
Disconnect nefative battery cable
before disconnecting and
reconnecting PCB harness.
There is battery voltage at the PC8 at
all times. Failure to disconnect battery
cable will result in damage to
equipment or injury to personnel.
PCB BODY
LIGHT SWITCH
CONNECTOR
CONNECTOR
HARNESS
I RESISTANCE
AND CONTINUITY
I
8-4.500
OHMS
STEACE-R
TEST 91
1. Connect RED clip and BLACK clip to the
indicated terminals in the question.
2. Stan Test 91,0-4.500
Ohms.
3. Displayed reading is in ohms. Less than
5 ohms is continuity. If the resistance is over
4,500 ohms, STE/lCE-R displays .9.9.9.9.
I
DC VOLTAGE
W5
VOLTS
STEIICE-R
TEST 89
1. Connect RED clip to positive, BLACK clip to
negative or ground.
2. Start Test 99, DC Volts.
3. Displayed reading is in volts.
FROM OFF TO ANY ON POSlTlON EXCEPT B.O. MARKER,
UNLOCK SWITCH MUST BE UFTED TO UNLOCK.
2-377
