TM 9-2320-387-24-l
REFERENCE INFORMATION
Don’t forget that your vehicle batteries
are disconnected,
so you can’t run the
SLUICE-R
from the DCA. You have to
use the power cable and connect
directly to the batteries.
When the resistance is too high for
STEXE-R
to measure, as in the case
of an open circuit, STEACE-R displays
.9.9.9.9.
Replace rotary switch (para. 4-10).
Dont forget that your vehicle batteries
are disconnected,
so you can’t run the
STMCE-R
from the DCA. You have to
use the power cable and connect
directly to the batteries.
When the resistance is too high for
SLUICE-R
to measure, as in the case
of an open circuit, STUICE-R
displays
.9.9.9.9.
Replace rotary switch (para. 4-10).
STARTER CIRCUIT
RESISTANCE AND CONTINUITY
04,500 OHMS
STfYlCE-R TEST 91
I
1. Connect RED clip and BLACK clip to the
indicated test points in the question.
RED to
the first, BUCK
to the second.
2. Start Test 91,0-4.500
Ohms.
3. Displayed reading is in ohms. Less than 5
is continuity.
If the resistance is over 4,500
ohms, STEXE-R
displays .9.9.9.9.
CONTINUITY (RESISTANCE)
MULTIMETER
1. Set the voltmeter to an ohms scale of about
1,000 ohms.
2. Connect the RED and BLACK leads to the
connections stated in the question.
3. Be sure to read the correct scale. Less than 5
ohms indicates continuity.
For an open circuit,
the meter should peg full scale (needle all the
way to the left).
REAR OF ROTARY SWtTCH
2-263
