TM 9-2320-387-24-l
8-5. RUNFLAT COMPRESSOR (P/N J39250) BELT REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
%&al
mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/P&s
Runflat belt repair kit
(Appendix G, Item 364)
Manual References
TM 9-2320-387-24P
Maintenance Level
Unit
p?iizi-l
NOTE
Note position of belt for installation.
1. Remove small pin (8) from belt (4) and worm gear shaft assembly (1). Discard small pin (8).
2. Remove shaft pin (7) and worm gear shaft assembly (1) from compressor assembly (6). Discard shaft
pin (7).
3. Remove two locknuts (51, socket-head screws (21, spacers (31, and belt (4) from compressor assembly (6).
Discard locknuts (51.
I- b. Installation
1
NOTE
Belt overlap is to be positioned so there is an equal amount of belt
on each side of worm gear shaft assembly.
1. Install belt (4) on compressor assembly (6) with two spacers (3), socket-head screws (2), and locknuts 6).
2. Install worm gear shaft assembly (1) on compressor assembly (6) with shaft pin (7).
3. Install belt (4) to worm gear shaft assembly (1) with small pin (8).
8-17
