TM 9-2320-362-14&P
4-18. EES KIT INSTALLATION (Contd)
hh. M16 Rifle Mount Installation
1.
2.
3.
4.
5.
NOTE
Procedures for replacing the left and right
rifle mounts are
procedure covers
Align holes on left side
dashboard bracket (1).
Using clamp bracket (4),
dashboard bracket (l).
When drilling,
basically the same.
This
the right rifle mount.
of clamp bracket (4) with rivets (2) on
determine center of two new holes (3) on
WARNING
be sure to wear goggles for eye
protection or injury to personnel may occur.
Avoid skin contact with paint, primer, remover,
and thinner particularly if there are cuts or
open wounds on the hand.
Failure to do so
could result in serious injury.
NOTE
Pin may need to be removed from hinge on drivers
side for easier installation.
Using 1/4-inch drill bit, drill out two new holes (3).
NOTE
Stuffing rag in hole at top of support may prevent
loss of hardware or tools.
Using two capscrews (6), washers (5), and self-locking nuts (11),
install clamp bracket (4),
NOTE
Ensure spring-loaded side of mounting clamp is
to outside of vehicle.
Using two machine screws (7), washers (9), and self-locking nuts
(10), install mounting clamp (8).
4-86