TM 9-2320-362-14&P
4-18. EES KIT INSTALLATION (Cont’d)
ff. Hand Throttle Cable Installation
1.
2.
3.
4.
5.
6.
7.
8.
9.
4-82
Remove existing hand throttle cable and bracket (TM 9-2320-280-20).
Retain the following items:
(a) Hitch pin (17) and washer (18) that secures clevis (20) to
accelerator rod (19);
(b) Two capscrews (1) and four washers (2) from lower mounting
bracket; and
(c) Capscrew (13), two washers (7), screw (14), and nut (5)
from upper mounting bracket.
Attach hand throttle bracket (8) to instrument panel (9) with
screw (14) and nut (5).
Do not tighten.
Secure hand throttle bracket (8) to instrument panel (9) with
capscrew (13), two washers (7), and locknut (6).
Tighten screw (14) and nut (5) that secures hand throttle
bracket (8) to instrument panel (9).
Install hand throttle cable (15) to hand throttle bracket (8).
Secure by tightening nut (10) and lockwasher (11) on hand throttle
cable (15).
Install hand throttle cable (15) to throttle cable end
bracket (16).
Tighten two washers (4) and nuts (3) on hand
throttle cable (15).
Install throttle cable end bracket (16) on cowl and secure with
two capscrews (1), four washers (2), and two self-locking
nuts (12).
Secure clevis (20) to accelerator rod (19) with washer (18) and
hitch pin (17).
