11-156.2
Change 1
Materials/Parts
Hose (Appendix D, Fig. D-119)
Fixture (Appendix D, Fig. D-117)
Bushing (Appendix D, Fig. D-118)
Manual References
TM 9-2320-280-24P
11-112.1. TURRET CLEANING
This task covers:
a. Turret Modification
b. Cleaning
a. Turret Modification
TM-9-2320-280-20-3
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038,
M1038A1, M1042, M1097, M1097A1,
M1097A2, M1123
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
NOTE
The following optional procedure will aid in turret cleaning. Have
your commander’s concurrence before performing any modification
to the vehicle.
1.
Locate and mark the position to drill hole (2) in inner bearing (1).
2.
Remove weapon station tray and seal (para. 11-112).
3.
Secure fixture (3) to inner bearing (1) with centerline of hole (4) aligned with mark on inner bearing (1).
4.
Position 0.339-in. drill bit (5) (letter R drill bit) four inches from drill chuck jaws (6).
NOTE
If not previously accomplished, perform task a. to allow use of hose
to clean turret.
