TM 9-2320-280-20-3
I
11-30. CARGO SHELL DOOR LINER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Applicable Models
M966, M966A1, M1025, M1025A1, M1025A2,
M1026, M1026A1, M1036
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Twelve clips (Appendix G, Item 14)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Rear end of cargo shell door raised
(TM 9-2320-280-10).
1. Remove ten screws (6), washers (5), clips (4), and two retainers (7) from cargo shell door (1).
2. Remove twelve fastener clips (8) from liner (3) and door (1). Discard fastener clips (8).
3. Remove liner (3) and three sound dampeners (2) from door (1).
4. Clean cargo door (1) to remove adhesive.
NOTE
1.
2.
3.
4.
5.
6.
Ensure surface is free of dirt and oil before applying adhesive
backing.
Apply three sound dampeners (2) to door (1).
Place four fastener clips (8) in two top and two bottom holes of liner (3). Ensure heads of fastener
clips (8) are on side of liner (3) without adhesive.
Peel paper backing (9) from liner (3).
Align liner (3) with door (1), ensuring top and bottom fastener clips (8) in liner (3) align with top and
bottom holes in door (1), and install liner (3) on door (1) with top and bottom fastener clips (8). Press
entire surface of liner (3) to ensure adhesion.
Install eight remaining fastener clips (8) through liner (3) into door (1).
Install two retainers (7) on door (1) with ten clips (4), washers (5), and screws (6).
11-48
