10-94. LEFT DEFROSTER NOZZLE REPLACEMENT
This task covers:
a. Removal
b.
Installation
1.
Remove eight capscrews (5) and retainer (6) from closeout panel (4) and A beam (7).
2.
Remove three nuts (20), washers (17), capscrews (16), and washers (17) from three clamps (18), cable
clamp (19), closeout panel (4), and A beam (7).
3.
Remove three screws (21) and closeout panel (4) from A beam (7).
4.
Loosen clamp (2.1) and disconnect defroster duct (3) from defroster nozzle (2).
5.
Remove locknut (9), lockwasher (10), washer (11), and pin (14) from steering column (15) and
bracket (13), and lower steering column (15). Discard locknut (9) and lockwasher (10).
NOTE
Perform steps 5.1 and 5.2 for M1097A2 and M1123 series vehicles only.
5.1.
Remove nut and lockwasher assembly (15.1), screw (15.3), and ground wire 57C (15.2) from steering
column (15).
5.2.
Remove locknut (15.5), washer (15.6), capscrew (15.8), washer (15.7), and two brackets (15.4) from
steering column (15). Discard locknut (15.5).
6.
Remove retaining pin (12) from defroster nozzle (2) and bracket (13).
NOTE
Note position of defroster nozzle for installation.
7.
Turn defroster nozzle (2) counterclockwise and remove from A beam (7).
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Lockwasher (Appendix G, Item 132)
Two locknuts (Appendix G, Item 106)
Adhesive sealant (Appendix C, Item 10)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Hood raised and secured (TM 9-2320-280-10).
Engine access cover removed (para. 10-15).
TM 9-2320-280-20-3
10-160
Change 1
a. Removal
1.
Install defroster nozzle (2) on A beam (7).
2.
Turn defroster nozzle (2) clockwise until defroster nozzle outlets (8) align with windshield frame
louvers (1).
3.
Install defroster nozzle (2) on bracket (13) with retaining pin (12).
NOTE
Perform steps 3.1 and 3.2 for M1097A2 and M1123 series vehicles only.
3.1.
Install two brackets (15.4) on steering column (15) with washer (15.7), capscrew (15.8),
washer (15.6), and locknut (15.5).
3.2.
Install ground wire 57C (15.2), screw (15.3), and nut and lockwasher assembly (15.1) on steering
column (15).
4.
Place steering column (15) in desired position, and install on bracket (13) with pin (14), washer (11),
lockwasher (10), and locknut (9). Tighten locknut (9) to 31 lb-ft (42 Nm).
5.
Apply adhesive and connect defroster duct (3) to defroster nozzle (2) and tighten clamp (2.1).
b. Installation
