Figure D-88. Mud Flap.
TM 9-2320-280-20-3
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont’d)
INSTRUCTIONS:
1.
2.
3.
4.
5.
6.
7.
Cut aluminum sheet metal to size as shown.
Locate, mark, and drill two .75 X .40 in. slots in mud flap plate.
Locate, mark, and drill two .40 in. diameter holes in mud flap plate.
Remove all burrs and sharp edges.
Locate, mark, and drill eight holes in angle bracket (5) as shown.
Paint as required. Refer to TM 43-0139.
Install mud flap (1) between mounting bracket (2) and angle bracket plate (5) with four washers (3),
capscrews (6), washers (3), and locknuts (4).
D-67
