TM 9-2320-280-20-2
9-15. TRANSMISSION MOUNT CROSSMEMBER REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual References
General mechanic’s tool kit:
TM 9-2320-280--24P
automotive (Appendix B, Item 1)
Materials/Parts
Four locknuts (Appendix G, Item 107)
CAUTION
Transmission must be supported during removal and installation of
transmission mount crossmember to prevent damage to equipment.
1.
2.
3.
4.
NOTE
Perform step 1 and 2 for all vehicles except “A2” series. Perform
steps 3 and 4 for ‘A2” series only.
Place support under transmission and remove two locknuts (8), washers (2), capscrews (3) and
washers (2) from transmission mount crossmember (5) and two transmission support brackets (1).
Discard locknuts (8).
Remove two locknuts (7), washers (6), and crossmember (5) from transmission mount (4). Discard
locknuts (7).
Place support under transmission and remove two locknuts (12), washers (11), capscrew (10) and
washer (11) from crossmember (13) and two support brackets (1).
Remove two locknuts (15), washers (14), and crossmember (13) from transmission mount (9).
b. Installation
1.
2.
3.
4.
6.
9-22
NOTE
Perform step 1 and 2 for all vehicles except “A2” series. Perform
steps 3 and 4 for “A2” series only.
Install crossmember (5) on two support brackets (1) with washers (2), capscrews (3), washers (2), and
locknuts (8). Tighten locknuts (8) to 90 lb-ft (122 N m).
Install crossmember (5) on transmission mount (4) with two washers (6) and locknuts (7). Tighten
locknuts (7) to 29 lb-ft (38 N m).
Install crossmember (13) on two support brackets (1) with washer (11), capscrew (10), two washers (11),
and locknuts (12). Tighten locknuts (12) to 90 lb-ft (122 N m).
Install crossmember (13) on transmission mount (9) with two washers (14) and locknuts (15). Tighten
locknuts (15) to 28 lb-ft (38 N m).
Remove support.
