1.
Apply sealing compound adhesive to threads of capscrews (6), (20), (21), and (1).
2.
Install power steering pump (8) on power steering bracket (7) with capscrew (6), short capscrew (20),
and two long capscrews (21). Tighten capscrews (6), (20), and (21) to 40 lb-ft (54 N•m).
3.
Using pulley installer, install pulley (3) on power steering pump (8) with washer (2) and cap-
screw (1). Tighten capscrew (1) to 37 lb-ft (50 N•m).
1.
Apply sealing compound to studs (15) and install support bracket (18) to studs (15) with two
nuts (19). Tighten nuts (19) to 45 lb-ft (61 N•m).
2.
Install power steering pump (8), pulley (3), and power steering bracket (7) on alternator bracket (9)
with washer (14), lockwasher (13), and capscrew (12).
3.
Install power steering bracket (7) to support bracket (18) with washer (22), lockwasher (23), and
capscrew (24).
4.
Install four drivebelts (16) and (17) onto pulley (3).
5.
Install power steering bracket (7) to alternator bracket (9) with lockwasher (5) and capscrew (4).
6.
Pull alternator (10) away from engine. Tighten alternator adjusting capscrew (29) and two
alternator mounting capscrews (11) finger tight.
7.
Connect two return lines (25) to power steering pump (8) and secure with two clamps (26).
8.
Install O-ring seal (27) on high pressure line (28) and connect high pressure line (28) to power
steering pump (8).
NOTE
Perform step 1 if support bracket was removed.
8-24. POWER STEERING PUMP, PULLEY, AND BRACKET MAINTENANCE (6.2L)(Cont‘d)
c. Assembly
d. Installation
TM 9-2320-280-20-2
8-74
Change 2
