TM 9-2320-280-20-2
7-18.2
Change 2
7-8.1. BRAKE PROTECTION GUARDS REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Applicable Models
All M1123 and “A2” series vehicles
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Twelve locknuts (without 10,500 lb hydraulic
winch) (Appendix G, Item 63.1)
Nine locknuts (with 10,500 lb hydraulic
winch) (Appendix G, Item 63.1)
NOTE
Perform steps 1 through 4 for vehicles equipped with 10,500 lb
hydraulic winch only.
1.
Remove two locknuts (3), washers (4), capscrews (18), washers (4), spacer (21), and left front brake
protection guard (19) from bracket (20) and bumper (22). Discard locknuts (3).
2.
Remove four locknuts (8), washers (9), capscrews (16), washers (9), two spacers (21), and right front
brake protection guards (10) from bracket (7) and bumper (13). Discard locknuts (8).
3.
Remove locknut (1), washer (2), capscrew (6), washer (2), and bracket (20) from front rear
crossmember (5). Discard locknut (1)
4.
Remove two locknuts (11), washers (12), capscrews (15), washers (12), and bracket (7) from front
crossmember (5). Discard locknuts (11).
5.
Remove two locknuts (3), washers (4), capscrews (18), washers (4), and left front brake protection
guard (19) from brackets (17) and (20). Discard locknuts (3).
6.
Remove four locknuts (8), washers (9), capscrews (16), washers (9), and right front brake protection
guards (10) from brackets (7) and (14). Discard locknuts (8).
7.
Remove two locknuts (1), washers (2), capscrews (6), washers (2), and brackets (17) and (20) from
front rear crossmember (5) and front crossmember (13). Discard locknuts (1).
8.
Remove four locknuts (11), washers (12), capscrews (15), washers (12), and brackets (7) and (14)
from front rear crossmember (5) and front crossmember (13). Discard locknuts (11).
a. Removal
Manual References
TM 9-2320-280-24P
Equipment Condition
Vehicle raised and supported (para. 8-2).
