TM 9-2320-280-20-2
4-98. CONTROL BOX POWER CABLES REPLACEMENT (Cont’d)
7.
8.
9.
10.
11.
12.
13.
14.
Remove two screws (1) and three clamps (3) from power harness (8), resuscitator harness (2) and
body (6).
Remove screw (1) and clamps (3) and (7) from body (6) and power harness (8).
Remove grommets (4) and (9), power harness (8), and resuscitator harness (2) from floor (5)
and body (6).
Remove grommet (23) from battery box (20).
Remove capscrew (10), lockwasher (11), ground cable (13), and two cables (12) from shunt (16)
Discard lockwasher (11).
Remove two screws (14), clamps (17), and positive cable (15) from battery box (20).
Remove nut (22), lockwasher (21), two battery cables (19), and positive cable (15) from power
stud (18) . Discard lockwasher (21).
Remove power harness (8) from vehicle.
b. Installation
1.
2.
3.
4.
5.
6.
7.
8.
Route power harness (8) in approximate mounting location in vehicle.
Install positive cable (15) and two battery cables (19) on power stud (18) with lockwasher (21) and
nut (22).
Install two clamps (17) on positive cable (15) and battery box (20) with two screws (14).
Install ground cable (13) and two cables (12) on shunt (16) with lockwasher (11) and capscrew (10).
Install grommet (23) on power harness (8) in battery box (20).
NOTE
Steps 6 thru 8 apply to M996 and M996A1 vehicles only.
Install clamp (7), power harness (8), and resuscitator harness clamp (3) on body (6) with screw (1).
Install three clamps (3), power harness (8), resuscitator harness (2), on body (6) with two screws (1).
Install power harness (8) and resuscitator harness (2) with two grommets (4) and (9) in floor (5) and
body (6).
4-190
