TM 9-2320-280-20-2
4-93. REAR DOOR LACKOUT SWITCH/BRACKET MAINTENANCE
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Manual References
M996, M996A1, M997, M997A1, M997A2
TM 9-2320-280-10
Tools
TM 9-2320-280-24P
General mechanic’s tool kit:
Equipment Condition
automotive (Appendix B, Item 1)
Battery ground cable disconnected
Materials/Parts
(para. 4-73).
Rear doors lowered (TM 9-2320-280-10).
Nut and lockwasher assembly
(Appendix G, Item 146)
Two lockwashers (Appendix G, Item 111)
Two locknuts (Appendix G, Item 62)
1.
2.
3.
4.
5.
Remove two locknuts (6), washers (2), capscrews (3), and washers (2) from bracket (1) and bracket (7).
Discard locknuts (6).
NOTE
Prior to removal, tag leads for installation.
Disconnect two leads (4) from leads (5). Remove bracket (1).
Remove two screws (18), lockwashers (17), and leads (14) and (16) from switch (15). Discard
lockwashers (17).
Remove two nuts (13), washers (12), screws (9), switch (15), switch lever (11), and spacer plate (10)
from bracket (1).
NOTE
Perform step 5 only if wiring harness is damaged.
Remove nut and lockwasher assembly (20) screw (8), clamp (19) and wiring harness (21) from
bracket (1). Discard nut and lockwasher assembly (20).
1.
2.
3.
4.
5.
4-170
NOTE
Perform step 1, only if wiring harness was removed.
Install clamp (19) and wiring harness (21) on bracket (1) with screw (8) and nut and lockwasher
assembly (20).
Install spacer plate (10), switch lever (11), and switch (15) on bracket (1) with two screws (9),
washers (12), and nuts (13).
Install leads (14) and (16) on switch (15) with two lockwashers (17) and screws (18).
Connect two leads (4) to leads (5).
Install bracket (1) on brackets (7) with two washers (2), capscrews (3), washers (2), and locknuts (6).
