4-81. SLAVE RECEPTACLE AND CABLE MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Inspection
a. Removal
1.
Remove capscrew (8), lockwasher (9), slave negative cable (10), and battery negative cable (11) from
shunt (1). Discard lockwasher (9).
2.
Remove nut (7), lockwasher (6), washer (5), battery positive cable (4), and slave positive cable (3)
from power feed stud (2). Discard lockwasher (6).
3.
Remove four nut and lockwasher assemblies (13), capscrews (18), receptacle (19), and cover (17) from
battery box (12). Discard nut and lockwasher assemblies (13).
NOTE
• Prior to removal, tag leads for installation.
• Perform steps 4 through 7 for vehicles with serial number 1
through 99,999.
• Perform steps 8 through 10 for vehicles with serial numbers
100,000 and above.
4.
Slide rubber boot (14) back to allow access to slave receptacle (19) connections.
5.
Remove capscrew (21), lockwasher (20), slave negative cable (10) from receptacle (19). Discard
lockwasher (20).
6.
Remove capscrew (16), lockwasher (15), slave positive cable (3) from receptacle (19). Discard
lockwasher (15).
7.
Remove rubber boot (14).
8.
Loosen compression nut (23) on backshell (22) and remove backshell (22) from receptacle (19).
9.
Remove capscrew (21), lockwasher (20), and slave negative cable (10) from receptacle (19). Discard
lockwasher (20).
10.
Remove capscrew (16), lockwasher (15), and slave positive cable (3) from receptacle (19). Discard
lockwasher (15).
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Four lockwashers (Appendix G, Item 108)
Four nut and lockwasher assemblies
(Appendix G, Item 145)
Grease (Appendix C, Item 24)
Manual Reeferences
TM 9-2320-280-24P
Equipment Condition
_________________
• Battery tray removed (para. 4-80).
• TOW wiring harness removed from power feed
stud and shunt (para. 11-67).
M966, M966A1 M1036, M1045, M1045A1,
M1045A2, M1046, M1046A1, M1121 only.
TM 9-2320-280-20-2
4-138
Change 2
