2-154
Change 1
(6) Loosen clamp (2) securing weathercap (1) to air intake assembly (3)
and remove weathercap (1).
(7) Remove nut (7), washer (5), capscrew (4), washer (5), and air intake
assembly (3) from windshield mounting bracket (6).
(8) Disconnect fuel tank vent line (11) from intake assembly vent tube (8).
(9) Loosen clamp (9) securing air intake assembly (3) to cowling (10) and
remove air intake assembly (3) and clamp (9).
(10) Install shield (12) in cowling (10) with three washers (13) and
capscrews (14).
(11) Install weathercap (1) and clamp (2) on shield (12) and tighten
clamp (2).
(12) Lower and secure hood (para. 3-8).
(13) Clean and stow intake and exhaust assembly components.
(14) If fording operation was through salt water, wash and wipe off all salt
deposits as soon as possible.
NOTE
To prevent parking brake linkage from binding, lithium grease
should be used after operating in mud. Clean mud, grit, and debris
from linkage. Apply lithium grease (Appendix D, Item 10.1) and
move linkage back and forth to work into joints.
(15) Vehicles completing deep water fording operation must be lubricated
and serviced by unit maintenance as soon as possible.
TM 9-2320-280-10
