TM 10-5411-231-13&P
CARGO BED COVER (CBC) HMMWV, TYPE I
0010 00
SERVICE UPON RECEIPT
Detach the pallet from CBC by removing the six bolts, nuts and washers. Save hardware for later use
in reshipment. Attach a lifting device capable of lifting at least 1 ton to each of four lift rings located
near the top corners of the CBC, and remove from pallet. The CBC is ready to be installed.
WARNING
Safe loading of the CBC requires two personnel. Stay clear of the unit while lifting, as
serious injury can result if unit swings or drops and hits personnel.
INSTALLATION
Attach CBC to a lifting device by hooking onto the four lift rings and set CBC onto a HMMWV. Open
CBC upper and lower doors. Carefully align the six predrilled holes on floor of CBC with holes located
on HMMWV bed.
Remove the kit installation hardware (P/N 104244) supplied and located in a bag attached to the 24”
ladder. Using this hardware, attach CBC to HMMWV as follows and refer to the CBC Installation
illustration.
1. Insert three bolts (2) with three rubber gaskets (6) through the holes on top, located at the forward
end of the CBC. From below, attach three flat washers (3) and three self-locking nuts (5). Attach
plates (7), one on the left side and one on the right side of CBC underneath the HMMWV. Attach
plate (8) with hole in center, in the center of CBC, and underneath the HMMWV. See illustration.
Hand tighten.
2. Insert three screws (4) through the holes on top (through the door frame tabs), located at the aft
end of the CBC.
3. From below, attach three flat washers (3) and three self-locking nuts (5). Hand tighten.
4. Securely tighten all six nuts (5) from below.
Lift Ring
END OF TASK
0010 00-2
