TM 10-5411-231-13&P
CARGO BED COVER (CBC) HMMWV, TYPE I
0010 00
SERVICE UPON RECEIPT
THIS WORK PACKAGE COVERS:
Unpacking, Assembly and Preparation for Use, Installation
INITIAL SETUP:
Maintenance Level
Personnel Required
Unit
Forklift Operator
Tools and Special Tools
2 Personnel (Non MOS specific)
Wrench, 9/16” Socket
Philips #3 Screwdriver
1-Ton Lifting Device
7/32” Allen Wrench
UNPACKING
The CBC is shipped as a complete, self-contained assembly. It is bolted to a wooden pallet, compatible
with 463L specifications. The CBC is attached to the pallet with three bolts, rubber gaskets, flat
washers and nuts at the forward end and three screws, mounting plates, flat washers and nuts at the aft
end.
1. Using socket wrench, remove three bolts, rubber gaskets and nuts holding forward end of the CBC
to the pallet.
2. Using screwdriver, remove three screws, mounting plates, washers and nuts holding aft end of the
CBC to the pallet. Save hardware in a plastic bag for future use in reshipment.
CHECKING UNPACKED EQUIPMENT
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged,
report the damage on SF 361, Transportation Discrepancy Report.
Check the equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with applicable service instructions (e.g. for Army instructions, see DA
PAM 738-750)
ASSEMBLY AND PREPARATION FOR USE
The CBC requires an installation kit to be installed onto a HMMWV vehicle. It is installed as a complete
unit. No assembly is required.
Open both ventilators to allow fresh air to be circulated. If electronic equipment is to be used inside the
CBC, determine if electrical power will be supplied from the road side or curb side of theCBC. Open the
access plate facing the power source by rotating it counterclockwise. When opened, the access plate
will be suspended by a lanyard attached inside the CBC.
0010 00-1
