3-1. LUBRICATION ACCORDING TO HIGH ENGINE IDLE TIME LOAD
Due to the mission profile, this vehicle operates under unusual conditions
(high idle time load). Therefore, mileage identified by LO 9-2320-280-12
for the vehicle is not sufficient; mileage plus engine idle time (using
hourmeter) must be used.
One hour of engine idle time is equal to 30 miles
The vehicle log should be updated daily to reflect engine idle
time and equivalent mileage (idle time in hours multiplied by 30 miles
equals the equivalent mileage).
REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
3-2. COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
3-3. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special tools, TMDE, and support equipment are listed and illustrated in
appendix D of this manual.
Repair parts are listed and illustrated in appendix D of this manual.
SERVICE UPON RECEIPT
Upon receipt of new, used, or reconditioned
kit, you must determine if the equipment has been
The following steps should be followed:
(1) Inspect all assemblies, subassemblies,
sure they are in proper working order.
(2) Secure, clean, lubricate, or adjust as
components of the EES
properly prepared for
and accessories to be
(3) Check all equipment to be sure every item is present, in good
condition, and properly mounted or stowed.
The operator will assist when performing service upon receipt