TM 9-2330-392-14&P
- NOTES -
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable Always wear protective goggles and gloves and use solvent only in a
well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat. The solvent’s flash point is 100 oF to 138•F(38•C to 59 °C). If you become dizzy while using
cleaning solvent, immediately get fresh air and medical help. If solvent contacts eyes, immediately wash your eyes with
water and get medical help
1.
FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW - 10 °F (- 23 °C). Remove
lubricants prescribed m the KEY for temperatures above - 10 °F (- 23 °C). Clean parts with dry cleaning solvent
(Appendix E, item 5). Lubricate with lubricants specified m the KEY for temperature 0 F (- 18 °C) to - 65 °F ( - 54 °C).
2.
OIL CAN POINTS. Semiannually, or as required, lubricate handbrake levers and linkage, hydraulic brake actuator
assembly, shock strut pivot and slide points, front support leg pivot points and hand-crank, rear stabilizer pivot points
and latches, and tailgate hinges and latches
3.
MASTER CYLINDER. Semiannually, or as required, fill to within 1/8 inch (3 mm) of top edge of reservoir. 4. WHEEL
BEARINGS. Semiannually, or as required, remove, clean, inspect, pack with GAA, and install. Refer to TM 9-214,
Inspection, Care, and Maintenance of Antifriction Bearings
G-6
