TM 9-2320-387-24-2
25-36.2
Change 1
25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR
,
NOTE
Tag hydraulic lines for assembly
1.
Remove banjo screw (8), two copper washers (9), and inlet banjo tube (10) from valve and solenoid
assembly (3). Discard copper washers (9).
2.
Remove banjo screw (6), two copper washers (5), and outlet banjo tube (7) from valve and solenoid
assembly (3). Discard copper washers (5).
NOTE
Restrictor, restrictor washer, and O-ring may come out of valve
and solenoid assembly during removal. Be careful to catch parts
during disassembly.
3.
Remove four socket-head screws (4) and valve and solenoid assembly (3) from motor (1).
4.
Remove two O-rings (2) from motor (1). Discard O-rings (2).
5.
Remove restrictor (11), restrictor washer (13), and O-ring (12) from valve and solenoid
assembly (3).
a. Disassembly
Tools
General mechanics tool kit: automotive
(Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Four copper washers (Appendix G, Item 24.1)
Two O-rings (Appendix G, Item 293.1)
O-ring (Appendix G, Item 293.2)
Two O-rings (Appendix G, Item 293.3)
O-ring (Appendix G, Item 293.4)
Two O-rings (Appendix G, Item 293.5)
Grease (Appendix C, Item 33)
Adhesive (Appendix C, Item 3.1)
Hydraulic fluid (Appendix C, Item 37)
Manual References
TM 9-2320-387-24P
Equipment Condition
Winch removed (M1113) (para. 12-27.1)
Winch removed (M1114) (para. 12-36.1)
Maintenance Level
Direct Support
This task covers:
a. Disassembly
c. Inspection
b. Cleaning
d. Assembly
INITIAL SETUP:
