TM 9-2320-387-24-2
1
1528.
ENGINE INSTALLATION (Cont’d)
27.
28.
29.
30.
31:
Connect lead 36A (2) to oil pressure sending unit (1).
Connect oil cooler supply line (4) and oil cooler return line (5) to engine (3).
Connect two leads 458A (12) to leads 458C (31) and 458D (13).
Connect engine harness lead 349A (20) to body harness leads 350B/359A/355A (21).
Install clamp (17) and body harness (16) on dipstick support bracket (14) with screw (15) and
nut (18).
32.
33.
34.
35.
Connect control valve hose (19) to control valve (23) and hose (25) to hydro-booster (27) and tighten
clamps (22) and (26) to lo-20 lb-in. U-2 Nem).
Connect two clamps (29) with capscrew (30), washer (28), and nut (24).
Connect high-pressure line (32) to hydro-booster (27).
Connect fuel inlet (48) and fuel outlet (49) lines to fuel filter (45) and tighten clamps (46) and (47).
NOTE
36.
37.
38.
39.
40.
41.
Perform steps 36 and 37 for Ml113 models only.
Connect engine harness connector (39) to time-delay module (42).
Connect harness connector plug (40) to protective control box (41).
Apply antiseize compound to engine harness ground 3C (51) and body harness ground 58B (52) and
install on body (33) with nut and lockwasher assembly (50).
Install engine harness (35) on body (33) with clamp (34) and two screws (44).
Install engine harness (35) on A-beam (36) with clamp (38), capscrew (37), and nut (43).
Connect harness lead 33B (9) to engine temperature sending unit (8) and harness lead (11) to
engine x-pm sensor lead (10).
42. Install two leads (7) on water temperature sending unit (6).
15-106
