TM 9-2320-387-24-2
Section
IV. REMARKS
(11
REFERENCE
(21
CODE
REMARKS
A
B
C
D
E
F
G
H
I
J
K
L
M
N
0
P
Calibration time will be established when support equipment requirements are
identified.
Operator drains water from fuel filter assembly. All other service is performed at
unit level.
Operator replenishes coolant. All other service is performed at unit level.
Operator inspects shift lever. All other inspections are performed at unit level.
Direct support maintenance repairs coupling shaft by replacing center bearing. All
other repair is performed at unit level.
In this category, no specific times can be established. Time required for repair will
depend on the extent of repair required for damaged components.
Simplified Test Equipmentnntemal Combustion Engine-Reprogrammable
(STE/ICE-R) testing times may vary depending on the type of tests being performed.
For vehicles with new brake adapters, P/N 10453002.
It is authorized to remove spindle to replace the seal. All other repair is performed at
direct support level.
Runflat compressor must be used with rubber runflat.
If the puller kit is not available at unit level, it can be found in the GSA catalogue,
Blind Hole Puller Set, NSN 5120-00-140-3557.
This tool can be found in the MCRL or GSA catalogue, Manometer, U-Tube,
NSN 6685-00-857-4895.
Fan shroud repair is limited to repairs that can be made using fiberglass repair kit
(appendix C, item 57). Only those repairs that can be made while the shroud is
installed on the vehicle are authorized.
Operator can remove and replace wheel assembly, but must notify unit maintenance
to tighten lug nuts to proper torque as soon as possible.
Direct support replaces fuel injection pump governor cover gasket, shut-off solenoid,
and cold-advance solenoid.
Direct support can reseal transfer case and transfer case housing with silicone
sealant, (RTW, NSN 6850-01-159-4844.
B-24
