TM 9-2320-387-24-2
33-2
Change 1
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Locknut (Appendix G, Item 174)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
• Hood raised and secured (front mounts only)
(TM 9-2320-387-10).
• Left rear underbody armor removed (M1114 only)
(para. 11-37).
• Right rear underbody armor removed (M1114
only) (para. 11-39).
Maintenance Level
General support
1.
Remove locknut (2), washer (1), capscrew (7), washer (8), and spacer (9) from sleeve (4), upper
cushion (5), lower cushion (10), body bracket (3), and frame bracket (6). Discard locknut (2).
2.
Place jack under body reinforcements adjacent to body mount to be removed.
3.
Raise body far enough to separate upper cushion (5) from lower cushion (10) and remove sleeve (4),
upper cushion (5), and lower cushion (10).
b. Installation
1.
Install lower cushion (10), upper cushion (5), and sleeve (4) between body bracket (3) and frame
bracket (6).
2.
Lower body and align lower cushion (10), sleeve (4), upper cushion (5), and body bracket (3) and
secure with spacer (9), washer (8), capscrew (7), washer (1), and locknut (2). Tighten locknut (2) to 90
lb-ft (122 N•m).
NOTE
• Replacement procedures for intermediate and rear body mounts
are identical.
• On front body mounts, capscrew is inserted down through upper
cushion.
• This procedure covers left intermediate body mount.
a. Removal
33-3. BODY MOUNT REPLACEMENT
This task covers:
a. Removal
b. Installation
