TM 9-2320-387-24-l
3-26. FUEL TANK SUPPLY AND RETURN LINES REPLACEMENT
This task covers:
a. Removal
b. Installation
I
--
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
‘ItKo locknuts (Appendix G, Item 109)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Engine right splash shield removed (para. 10-24).
General Safety Instructions
Do not perform this procedure near fire, flames, or
sparks.
Maintenance
Level
unit
WARNING
Diesel fuel is highly flammable. Do not perform this procedure
near fire, flames, or sparks. Severe injury or death may result.
[I
CAUTION
*
Cover or plug all open hoses and connections immediately after
disconnection to prevent contamination. Remove all plugs prior to
connection.
NOTE
Have drainage container ready to catch fuel.
1.
Loosen four clamps (71 and disconnect hoses (61 from fuel tank return and supply lines (8).
2.
Remove two locknuts (11, capscrews (51, washers (41, clamps (31, and return and supply lines (8) from
front body bracket (2) and rear body bracket (101. Discard locknuts (1).
3.
Remove three clips (9) from fuel supply and return lines (81.
)I
1.
Install return and supply lines (8) on front body bracket (2) and rear body bracket (10) with two
clamps (3), washers (41, capscrews (51, and locknuts (11.
2.
Connect supply and return lines (8) to four hoses (6) and tighten clamps (7).
3.
Secure fuel supply and return lines (8) together with three clips (91.
3-52
