TM 9-2320-387-24-l
Table 2-6. STE IKE-R
GO-Chain Tests.
INDICATES
VTM IS PROPERLY
I=
1
FORTESTS
CONNECTED
AND READY
GO-CHAIN
INDICATES
GO CONDiTlON
AFTER CONFIDENCE
TESTS
NOTE
Perform all GO steps until a NO-GO condition exists,
then perform the NO-GO
step indicated.
1
V
CAUTION
I
l Do not connect or disconnect the VTM while
the vehicle is running.
l Connect DCA cable to the VTM before
connecting to the diagnostic connector.
CONNECT VTM TO VEHICLE DIAGNOSTTC
CONNECTOR:
l PULL OFF the VTM power switch.
l Connect DCA cable to the VTM.
l Connect DCA cable to the vehicle.
l PUSH ON the VTM power switch.
l Verify that the display indicates .8.8.8.8
for opproximotely
2 seconds and then changes to - - - -.
l Does the VTM display .8.8.8.8
and then change to - - - - ?
II
I
1
l Proceed to step 3.
1
1 l Proceed to following page.
-27
I
J
J
AFTER
2 SECONDS
2-519