TM 9-2320-362-14&P
B-3. EXPLANATION OF COLUMNS IN THE MAC, SECTION II (Cont’d)
d.
Column (4) - Maintenance Level.
Column 4 contains the level of
maintenance authorized to perform the function listed in column 3,
specified by listing a work time figure in the appropriate subcolumn(s).
This figure represents the active time required to perform that maintenance
function at the indicated level of maintenance.
If the number or
complexity of the tasks within the listed maintenance function varies at
different maintenance categories, appropriate work time figures will be
shown for each level.
The work time figure represents the average time
required to restore an item (assembly, subassembly, component, module, end
item, or system) to a serviceable condition under typical field operating
conditions.
This time includes preparation time (including any necessary
disassembly/assembly time), troubleshooting/fault location time, and
quality assurance/quality control time in addition to the time required to
perform the specific tasks identified for the maintenance functions
authorized in the MAC.
The symbol designations for the various maintenance
categories are as follows:
C . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operator or crew
O . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Unit maintenance
F
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Direct support maintenance
H
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
General support maintenance
D
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Depot maintenance
e.
Column (5) - Tools and Equipment.
Column 5 contains a list, by code,
of those common tool sets (not individual tools) and special tools, TMDE,
and support equipment required to perform the designated function.
f.
Column (6) - Remarks.
Column 6, when applicable, shall contain a
letter code, in alphabetical order, which shall be keyed to the remarks
contained in section IV.
B-4. EXPLANATION OF COLUMNS IN TOOL AND TEST EQUIPMENT
REQUIREMENTS, SECTION III
a.
Column (1) - Reference Code.
The tool and test equipment reference
code correlates with a code used in the MAC, section II, column 5.
b.
Column (2) - Maintenance Level.
The lowest level of maintenance
authorized to use the tool or test equipment.
c.
Column (3) - Nomenclature.
The name or identification of the tool or
test equipment.
d.
Column (4) - National Stock Number.
The national stock number of the
tool or test equipment.
e.
Column (5) - Tool Number.
The manufacturer’s part number.
B-3
