TM 9-2320-280-20-3
10-48. THREE POINT SEATBELT MAINTENANCE
This task covers:
a. Front Seatbelt Removal
d. Rear Seatbelt Removal
b. Front Seatbelt Bracket Inspection
e. Rear Seatbelt Bracket Inspection
c. Front Seatbelt Installation
f. Rear Seatbelt Installation
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
l Passenger seat back removed, rear seatbelt only
(para. 10-45).
l Companion seat and battery box cover removed,
companion seatbelt only (para. 10-35).
l Four-man soft top curtain removed, rear seatbelt
only (TM 9-2320-280-10).
l Rear doors removed, armament vehicles only
(para. 11-2).
General Safety Instructions
Seatbelts are to be replaced as a set.
WARNING
Seatbelts are to be replaced as a set. Failure to do this may cause
injury to personnel or damage to equipment.
NOTE
Left and right seatbelt maintenance procedures are basically the
same. This procedure covers the left seatbelt.
a. Front Seatbelt Removal
1.
2.
3.
4.
5.
6.
7.
8.
10-76
Remove capscrew (26), buckle assembly (25), and washer (24) from body (23).
Remove capscrew (22), connector assembly (21), and washer (20) from bracket (19).
NOTE
Steps 3 and 4 apply to all armament vehicles.
Remove two screws (7) and washers (8) from “B” pillar cover (12) and roof (6).
Remove two screws (14), washers (13), and “B” pillar cover (12) from “B” pillar (11).
NOTE
Step 5 applies to armament vehicles with serial numbers USBL
Eff. 100,000 through 134,152 only.
Remove nut (9), washer (10), capscrew (1), “D” ring (2), washer (3), and bracket half (4) from
“B” pillar (11).
NOTE
Step 6 applies to armament vehicles with serial numbers USBL Eff.
134,153 and above only. Steps 7 and 8 apply to all other vehicles.
Remove capscrew (1), “D” ring (2), washer (3), and bracket halves (4) and (5) from “B” pillar (11).
Remove capscrew (15), “D” ring (16), and washer (17) from upper bracket (18).
Remove capscrew (27), washer (28), and retractor (29) from lower bracket (30).
