a. Removal
b. Installation
This task covers:
12-147. REAR RADIO RACK POWER CABLE REPLACEMENT
Tools
a. Removal
TM 9-2320-280-20-3
INITIAL SETUP:
Applicable Models
M998, M998A1, M1038, M1038A1
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Three lockwashers (Appendix G, Item 127)
Two locknuts (Appendix G, Item 65)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-24P
Equipment Condition
Battery ground cable disconnected (para. 4-73).
1.
2.
3.
4.
5.
Remove two locknuts (6), washers (4), capscrews (3), washers (4), power cable (1), and clamps (2)
from radio rack (5). Discard locknuts (6).
Remove two screws (8), clamps (7), power cable (1), and two antenna cables (12), if present, from
tunnel (11).
Remove grommet (9) from body (10) and power cable (1).
NOTE
It maybe necessary to loosen front shunt mounting bolt to remove
capscrew from shunt.
Remove nut (13), lockwasher (14), negative starter cable (15), nut (16), lockwasher (17),
capscrew (24), and power cable negative terminal (19) from shunt (18). Discard lockwashers (14)
and (17).
Remove nut (23), lockwasher (22), and power cable positive terminal (21) from power stud (20).
12-232
