a. Removal
TM 9-2320-280-20-3
12-140. REAR ANTENNA CABLES REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M1037, M1042, M1097,
M1097A1, M1097A2
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two tiedown straps (Appendix G, Item 242)
Eleven nut and lockwasher assemblies
(Appendix G, Item 146)
Three locknuts (Appendix G, Item 106)
Two lockwashers (Appendix G, Item 120)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
• Battery ground cable disconnected (para. 4-73).
• Right rear passenger seat back removed
(para. 10-45).
• Dual TSEC/KY-57 mounting bracket and control
switch bracket removed (para. 12-134) if
installed.
• Front floorboard removed (para. 11-154).
M966, M966A1, M1025, M1025A1, M1025A2,
M1026, M1026A1, M1043, M1043A1, M1043A2,
M1044, M1044A1, M1045, M1045A1, M1045A2,
M1046, and M1046A1 models only:
• Cargo shell door raised (TM 9-2320-280-10).
NOTE
• Left and right rear antenna cables are replaced basically the
same, except the left antenna cables have an additional six
clamps securing cables across rear of vehicle. This procedure
covers the right rear antenna cables.
• Perform steps 1 through 5 for front radio rack, and steps 6 and 7
for rear radio rack.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Remove two tiedown straps (6) from antenna cables (4). Discard tiedown straps (6).
Remove two nut and lockwasher assemblies (5), screws (2), two clamps (3), and antenna cables (4)
from front radio rack (1). Discard nut and lockwasher assemblies (5).
Remove nut and lockwasher assembly (11), capscrew (8), clamp (9) from two antenna cables (4), and
grommet (10). Discard nut and lockwasher assembly (11).
Remove two screws (12) and insulation retainer (13) from cargo floor (7) and pull away from cargo
floor (7).
Remove three screws (26), clamps (27), and two antenna cables (4) from body (19).
Remove two capscrews (23), washers (24), clamps (25), and antenna cables (18) from rear radio
rack (22) and cargo floor (7).
Remove two screws (20), clamps (21), and antenna cables (18) from body (19) and remove
clamps (21) from antenna cables (18).
Remove nut and lockwasher assembly (28), screw (17), and clamp (29) from two antenna cables (4)
and body (19). Discard nut and lockwasher assembly (28).
Remove two nut and lockwasher assemblies (14), capscrews (30), antenna cables (4), grommet (16),
and retainer (15) from body (19). Discard nut and lockwasher assemblies (14).
12-214
