TM 9-2320-280-20-3
11-197. BLOWER MOTOR RESISTOR REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Equipment Condition
M996, M996A1, M997, M997A1, M997A2
l Battery ground cable disconnected (para. 4-73).
l Blower housing open (para. 11-198).
Tools
. Heater compartment panel removed
General mechanic’s tool kit:
(M996 and M996A1 vehicles only) (para. 11-204).
automotive (Appendix B, Item 1)
Manual References
TM 9-2320-280-24P
NOTE
M996, M996A1, M997, M997A1, and M997A2 blower motor
resistors are replaced basically the same. This procedure covers
M997, M997A1, and M997A2 vehicles only.
1. Disconnect plug (1) from resistor (3).
2. Remove two screws (4) and resistor (3) from blower housing (2).
1. Install resistor (3) on blower housing (2) with two screws (4).
2. Connect plug (1) to resistor (3).
FOLLOW-ON TASKS: l
l
l
w
Close blower housing (para. 11-198).
Connect battery ground cable (para. 4-73).
Heater compartment panel installed (M996 and M996A1 vehicles only)
(para. 11-204).
11-291
