TM 9-2320-280-20-3
10-17. ENGINE LEFT SPLASH SHIELD MAINTENANCE (Cont’d)
1. Install bushing (17) on splash shield (15) with four rivets (18).
2. Install bracket (32) on splash shield (15) with two washers (26), capscrews (31),
washers (26), and locknuts (25). Tighten locknuts (25) to 6 lb-ft (8 Nom).
3. Install seal (5) and seal retainers (4) on splash shield (15) with seven capscrews (6), washers (7), and
locknuts (8).
NOTE
Perform step 4 only if vehicle has an armor plate.
4. Install armor plate (35) on splash shield (15) with washer (34), capscrew (36),
washer (34), and locknut (33). Tighten locknut (33) to 15 lb-ft (20 N-m).
d. Installation
1.
2.
3.
4.
5.
6.
7.
Install splash shield (15) on bracket (16) with washer (14), capscrew (19), washer (14), and
locknut (13).
Install harness and clamp (38) on splash shield (15) with screw (37) and nut and lockwasher
assembly (39).
Install connector receptacle (30) on bracket (32) with four lockwashers (29) and
screws (28).
Install splash shield (15) to airlift bracket (9) with washer (23), lockwasher (22), and capscrew (21).
Tighten capscrew (21) to 10 lb-ft (14 Nom).
Install splash shield (15) on airlift bracket (9) with washer (11), capscrew (20), washer (12),
washer (11), and locknut (10). Tighten capscrew (20) to 10 lb-ft (14 Nom).
Install splash shield (15) on support bracket (1) with washer (2), capscrew (24), washer (2), and
locknut (3). Tighten capscrew (24) to 6 lb-ft (8 Nom).
Connect hood harness (27) to connector receptacle (30).
10-30
