TM 9-2320-280-20-3
I
10-15. ENGINE ACCESS COVER MAINTENANCE (Cont’d)
3. Remove four retaining rings (8), two washers (7), ring studs (6), and washers (7) from access cover (5).
4.
Remove two locknuts (9), shoulder bolts (13), and latches (14) from access cover (5). Discard lock-
nuts (9).
5. Remove two rivets (12), backing plates (10), and guide plates (11) from access rover (5).
6. Remove two rivets (1) and keepers (2) from holddown brackets (3).
7. Remove four rivets (4), nuts (15), washers (16), capscrews (18), two holddown brackets (3), and
backing plates (17) from access cover (5).
I c. Assembly I
1.
Install two holddown brackets (3) and backing plates (17) on access cover (5) with four rivets (4),
capscrews (18), washers (16), and nuts (15).
2. Install two keepers (2) on holddown brackets (3) with rivets (1).
3. Install two backing plates (10) and guide plates (11) on access cover (5) with rivets (12).
4. Install two latches (14) on plates (11) and access cover (5) with shoulder bolts (13) and locknuts (9).
5. Install two washers (7) and ring studs (6) on access cover (5) with washers (7) and four retaining
rings (8).
6. Install seal (19) on access cover (5).
7. Install insulation (22) on access cover (5) with seven retainers (20) and rivets (21).
10-24
