10-99. “C” PILLAR REPLACEMENT
This task covers:
a. Removal
b.
Installation
a. Removal
1.
Remove four locknuts (6), washers (5), capscrews (4), washers (5), eight rivets (2), and two braces (3)
from “C” pillar (1) and wheelhouses (7). Discard locknuts (6).
2.
Remove four locknuts (8), washers (9), capscrews (11), washers (9), two plates (10), and “C” pillar (1)
from wheelhouses (7). Discard locknuts (8).
3.
Inspect rivnut (12) for damage. Replace if damaged.
INITIAL SETUP:
Applicable Models
M998, M998A1, M1035, M1035A1,
M1038, M1038A1
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Four locknuts (Appendix G, Item 58)
Four locknuts (Appendix G, Item 107.1)
Eight rivets (Appendix G, Item 195.1)
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Soft top removed (TM 9-2320-280-10).
b. Installation
1.
Install “C” pillar (1) on wheelhouses (7) with two plates (10), four washers (9), capscrews (11), washers (9),
and locknuts (8). Tighten capscrews (11) to 6 lb-ft (8 N•m).
2.
Install two braces (3) on wheelhouses (7) and “C” pillar (1) with four washers (5), capscrews (4),
washers (5), locknuts (6), and eight rivets (2).
TM 9-2320-280-20-3
10-168
Change 1
FOLLOW-ON TASK: Install soft top (TM 9-2320-280-10).
