TM 9-2320-280-20-2
8-19. STEERING COLUMN REPLACEMENT (Cont’d)
b. Installation
1.
2.
3.
4.
5.
6.
7.
8.
9.
8-60
NOTE
Perform step 1 for “A2” series vehicles only.
Install steering column (7) on mounting bracket (4) with two washers (23), screws (24), washers (23)
and locknuts (22). Tighten locknuts (22) finger tight.
Install steering column (7) on mounting bracket (4) with two shoulder bolts (9), washera (20), and
locknuts (19). Tighten locknuts (19) finger tight.
Install intermediate shaft (17) on steering column (7) with washer (13), capscrew (16), washer
and locknut (14). Tighten locknut (14) to 40-50 lb-ft (54-68 N m).
Connect lead 25A (21) to steering column (7).
Install two brackets (8) on steering column (7) with washer (11), capscrew (12), washer (11), and
locknut (10).
Install ground 57C (15) on steering column (7) with screw (9) and nut and lockwasher
assembly (18).
NOTE
Only vehicles with serial number 99,999 and below using
steering column part number 1419, are equipped with spacers
as indicated in step 7.
Insert washer and pin with locking tabs in the “up” position.
Secure steering column (7) to mounting bracket (4) with two spacers (5), pin (6), washer (3),
lockwasher (2), and locknut (1). Tighten locknut (1) finger tight.
Position steering column (7) in upright position and tighten locknut (1) to 12-15 lbft (16-20 N m).
Tighten locknuts (22) and (19) to 9-11 lb-ft (12-15 N m).
(13),
