TM 9-2320-280-20-2
7-21. REAR DUAL SERVICE/PARKING BRAKE PAD MAINTENANCE
This task covers:
a. Removal
c.
Installation
b. Cleaning and Inspection
Manual References
TM 9-2320-280-10
TM 9-2320-280-24P
Equipment Condition
Wheels chocked and parking brake released
(TM 9-2320-280-10).
Pioneer tool stowage rack removed
(TM 9-2320-280-10).
General Safety Instructions
Make sure brake pads are installed with linings
facing rotor.
7-48
Change 2
a. Removal
NOTE
The following procedure applies to vehicles with serial numbers
USBL, Eff, 44825 and above.
NOTE
Note positioning of brake pad surfaces for installation.
1.
Remove cotter pin (4), washer (5), and clevis pin (7) from parking brake clevis (6) and lever (3).
Discard cotter pin (4).
2.
Remove clip (2) and disconnect parking brake cable (8) from caliper cable bracket (1). Discard clips (2)
3.
Remove two capscrews (12), washers (13), and pull yoke (14) and caliper (15) away from rotor (10).
CAUTION
Use tiedown strap to support caliper during removal to prevent
damage to brake line.
4.
Remove two brake pads (9) from adapter (11) and rotor (10).
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Hex wrench (Appendix D, Fig. D 115)
Open end wrench (Appendix D, Fig. D 116)
Special Tools
Crowfoot, 14 mm (Appendix B, Item 152)
Materials/Parts
Clip (Appendix G, Item 13)
Cotter pin (Appendix G, Item 17)
Sealing compound (Appendix C, Item 45)
Grease (Appendix C, Item 22)
Tiedown strap (Appendix G, Item 241)
