TM 9-2320-280-20-2
6-5. REAR PROPELLER SHAFT MAINTENANCE (1330 SERIES)
This task covers:
a. Removal
c. Installation
b. Inspection
INITIAL SETUP:
Applicable Models
Manual References
M1097, “A1” and “A2” series
TM 9-2320-280-10
TM 9-2320-280-24P
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
1. Chock wheels and release parking brake (TM 9-2320-280-10).
2. Remove four capscrews (6), two straps (5), and disconnect propeller shaft (3) from differential pinion
yoke (4).
3. Slide propeller shaft end yoke (1) out of transfer case extension (2) and remove propeller shaft (3).
b. Inspection
1. Inspect propeller shaft (3) for cracks and dents. Replace if cracked or dented.
2. Inspect grease fittings and universal joints for serviceability. Replace universal joints (para. 6-6) or
grease fittings if unserviceable.
3. Inspect splined end of end yoke (1) for damage. Replace end yoke (1) if damaged (para. 6-6).
c. Installation
1. Slide propeller shaft end yoke (1) on transfer case extension (2) and install propeller shaft (3).
2. Connect propeller shaft (3) to differential pinion yoke (4) with two straps (5) and four capscrews (6).
Tighten capscrews (6) to 13-18 lb-ft (18-24 N m).
3. Apply parking brake (TM 9-2320-280-10) and remove wheel chocks.
6-10
