TM 9-2320-280-20-2
4-119. CONTROL BOX ELECTRICAL PLUG AND RECEPTACLE REPLACEMENT
This task covers:
a. Plug Removal
c. Receptacle Removal
b. Plug Installation
d. Receptacle Installation
INITIAL SETUP:
Applicable Models
Manual References
M996, M996A1, M997, M997A1, M997A2
TM 9-2320-280-24P
Tools
Equipment Condition
General mechanic’s tool kit:
Battery ground cable disconnected (para. 4-73)
automotive (Appendix B, Item 1)
(receptacle only).
a. Plug Removal
1. Turn and pull plug (4) from receptacle (3).
2. Remove two screws (5) from plug (4). Open plug (4) and ensure positive (10), negative (12), and
ground (11) leads for plug (4) are properly installed.
b. Plug Installation
1. Close plug (4) and install two screws (5) on plug (4).
2. Insert plug (4) on receptacle (3).
c. Receptacle Removal
N O TE
For instructions on replacement of rivets, refer to para. 10-66.
1. Remove two rivets (6) and receptacle (3) from control box (1). Pull receptacle (3) away for access to
leads (2).
N O TE
Prior to removal, tag leads for installation.
2. Loosen screw (8) and push shield (9) away for access to leads (2).
3. Remove two screws (7), and leads (2) from receptacle (3).
d. Receptacle Installation
1. Install two leads (2) on receptacle (3) with two screws (7). Position shield (9) over screws (7) and
tighten screw (8).
2. Install receptacle (3) on control box (1) with two rivets (6).
4-280
