2-43. STE/ICE-R TEST PROCEDURES
This paragraph will be helpful when using the STE/lCE-R to answer diagnostic questions. Use this
paragraph as a reference if you need additional information about a specific test. This paragraph
contains information such as possible errors, test procedure, control codes, and additional notes as
necessary. The following chart will help you find the test you need. The STE/lCE setup and internal
checks (test no. G01, Page 2-763) must be perfomed prior to performing tests. A complete description
and operation of the STE/lCE-R is found on Page 2-753. See TM 9-4910-571-12&P for additional
information.
TEST NAME
TEST #
ENGINE RPM (AVERAGE)
10
POWER TEST (RPM/SEC)
12
POWER TEST (PERCENT)
13
COMPRESSION UNBALANCE TEST
14
FUEL SUPPLY PRESSURE (PSI)
24
PRESSURE (PSI) 0 TO 1000
50
BATTERY VOLTAGE
67
STARTER MOTOR VOLTAGE
68
STARTER NEGATIVE CABLE VOLTAGE DROP
69
STARTER SOLENOID VOLTS
70
STARTER CURRENT AVERAGE
71
CURRENT FIRST PEAK
72
BATTERY INTERNAL RESISTANCE
73
STARTER CIRCUIT RESISTANCE
74
BATTERY RESISTANCE CHANGE
75
BATTERY CURRENT
80
DC VOLTAGE 0 TO 45 VOLTS
39
DC CURRENT 0 TO 1500 AMPS
90
RESISTANCE AND CONTINUITY 0 TO 4500 OHMS 91
PAGE #
2-734
2-735
2-736
2-737
2-733
2-739
2-740
2-741
2-742
2-743
2-744
2-745
2-746
2-747
2-748
2-749
2-750
2-751
2-752
2-733
