TM 9-2320-280-20-1
REFERENCE INFORMATION
Change 1 2-279
Don't forget that your vehicle batteries
are disconnected, so you can't run the
STE/ICE-R from the DCA, you have to
use the power cable and connect
directly to the batteries.
When the resistance is too high for
STE/ICE-R to measure, as in the case
of an open circuit, STE/ICE-R displays
“9.9.9.9.”
Check the wires at the connectors for
shorts. If there are no visible shorts,
you have to replace the harness.
CONTINUITY (RESISTANCE)
MULTIMETER
1. Set the voltmeter to an ohms scale of about
1000 ohms.
2. Connect the RED and BLACK leads to the
connections stated in the question.
3. Be sure to read the correct scale. Less than 5
ohms indicates continuity. For an open circuit, the
meter should peg full scale (needle all the way to
the left).
STARTER CIRCUIT
Repair wiring or replace harness,
refer to (para. 4-85).
Repair wiring or replace harness,
refer to (para. 4-85).
Replace starter, refer to (para. 4-8).
A
B
C
D
E
F
G
H
PCB/DISTRIBUTION BOX BODY CONNECTOR
0-4500 OHMS
STE/ICE-R TEST 91
1. Connect RED clip and BLACK clip to the
indicated test points in the question. RED to the
first, BLACK to the second.
2. Start Test 91, 0-4500 ohms.
3. Displayed reading is in ohms. Less than 5 ohms
is continuity. If the resistance is over 4500 ohms,
STE/ICE displays “9.9.9.9.”
