TM 10-5411-231-13&P
CARGO BED COVER (CBC) HMMWV, TYPE I
0023 00
MAINTENANCE ALLOCATION CHART (MAC)
Explanation of Columns in the MAC
Column (1) - Group Number. Column (1) lists Functional Group Code (FGC) numbers, the purpose of
which is to identify maintenance significant components, assemblies, subassemblies, and modules with
the Next Higher Assembly (NHA). End item group numbers are “00”.
Column (2) - Component/Assembly. Column (2) contains the names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
Column (3) - Maintenance Function. Column (3) lists the functions to be performed on the item listed in
Column (2). (For detailed explanation of these functions, refer to “Maintenance Functions” outlined
previously).
Column (4) - Maintenance Level. Column (4) specifies each level of maintenance authorized to perform
each function listed in Column (3), by indicating work time required (expressed as manhours in whole
hours or decimals) in the appropriate subcolumn. This work time figure represents the active time
required to perform that maintenance function at the indicated level of maintenance. If the number or the
complexity of the tasks within the listed maintenance function vary at different maintenance levels,
appropriate work time figures are to be shown for each level. The work time figure represents the
average time required to restore an item (assembly, subassembly, component, module, end item, or
system) to a serviceable condition under typical field operating conditions. This time includes
preparation time (including any necessary disassembly/assembly time), troubleshooting/fault location
time, and quality assurance time in addition to the time required to perform the specific tasks identified
for the maintenance functions authorized in the MAC. The symbol designations for the various
maintenance levels are shown as follows:
C ....... Operator or Crew Maintenance
H ....... General Support Maintenance
O ....... Unit Maintenance
D ....... Depot Maintenance
F ....... Direct Support Maintenance
Column (5), Tools and Equipment Reference Code. Column (5) specifies, by code, those common tool
sets (not individual tools) common Test, Measurement and Diagnostic Equipment (TMDE), and special
tools, special TMDE, and special support equipment required to perform the designated function.
Column (6), Remarks Code. When applicable, this column contains a letter code, in alphabetical order,
which is keyed to the remarks contained in Table 3.
Explanation of Columns in the Tools and Test Equipment Requirements
Column (1) - Tool or Test Equipment Reference Code. The tool or test equipment reference code
correlates with a code used in column (5) of the MAC.
Column (2) - Maintenance Level. The lowest level of maintenance authorized to use the tool or test
equipment.
0023 00-3
