TM 9-2320-387-24-2
12-68.28
Change 1
12-36.6. 10,500 LB REAR HYDRAULIC WINCH CONTROLLER PLUG REPLACEMENT (Cont'd)
1.
Route controller plug harness (1) through hole in body panel (10), around fuel filter (11), and along
body wiring harness (2) to valve assembly (9).
2.
Connect controller plug lead 785A (4) to valve assembly lead 785A (6).
3.
Connect controller plug lead 785B (3) to circuit breaker (8).
4.
Connect controller plug lead 785C (5) to valve assembly lead 785C (7).
5.
Align holes in controller plug (15) with holes (12) in body panel (10) and blind spline (16) at top
position and install controller plug (1) and cap and chain (14) on body panel (10) with four
screws (13).
6.
Secure lead wire (18), controller plug harness (1), controller plug harness leads (19), and valve
assembly wires (20) to body harness (2) with three tiedown straps (17).
b. Installation
1
2
11
10
3
4
5
6
7
8
9