6-12. GEARED HUB SPINDLE BEARING ADJUSTMENT (Cont'd)
FOLLOW-ON TASK: Install wheel (para. 8-3).
TM 9-2320-387-24-1
Change 1
6-37
10.
Clean sealing surfaces on geared hub (6) and steering arm cover (9). Apply anaerobic sealant to
steering arm cover (9) and install steering arm cover (9) on geared hub (6).
11.
Apply sealing compound to threads of four capscrews (11) and install steering arm cover (9) on
geared hub (6) with four washers (10) and capscrews (11). Tighten capscrews (11) to 65 lb-ft
(88 Nm).
12.
Remove fill plug (7) and washer (8) from geared hub (6).
13.
Fill geared hub (6) to proper oil level (para. 2-12).
14.
Install washer (8) and fill plug (7) on geared hub (6). Tighten fill plug (7) to 8-13 lb-ft (11-18 Nm).
CAUTION
When installing steering arm cover, ensure seal in cover is
aligned on spindle extension. Damage to seal will result if not
aligned.
NOTE
Immediately install steering arm cover after application of sealant.
6
7
8
6
11
10
9