1 2-11. GENERAL SERVICE AND INSPECTION PROCEDURES (Contd)
Drycleaning solvent is flammable and will not be used near an
open flame. A fire extinguisher will be kept nearby when the
solvent is used. Use only in well-ventilated places. Failure to do
this may result in injury to personnel and/or damage to
c. Where the instruction clean appears in a procedure, you must use drycleaning solvent (appendix C,
item 26) to clean grease or oil from metal parts. After the item is cleaned, rinsed, and dried, apply a light
grade of oil to unprotected surfaces to prevent rusting.
d. Clean rubber and plastic materials with soap and water. Refer to TM 9-2320-387-10 for general
vehicle cleaning instructions.
2- 12. SPECIFIC PMCS PROCEDURES
a. The preventive maintenance for which you are responsible is provided in table 2-l. The checks and
services listed are arranged in logical order, requiring minimal time and effort on your part.
b. The following columns read across on the PMCS schedule:
(1) Item Number. Provides logical order of PMCS performance and is used as a source number for
DA Form 2404, on which your PMCS results will be recorded.
Shows the interval next to each item number to indicate when that check is to be
performed. The interval will be repeated when consecutive item numbers are to be inspected during the
same interval. Interval columns include:
(a) Semiannual (six month) checks;
(b) Annual (yearly) checks; and
(c) Biennial (every two years) checks.
(3) Item To Be Inspected. Lists the system, common name, or location of the item to be inspected.
(4) Procedures Provides instructions for servicing, inspection, lubrication, replacement, or
adjustment and, in some cases, having item repaired at a higher level.
Always do your preventive maintenance checks and services in the
order prepared. Once it gets to be a habit, you will be able to spot
anything wrong in a hurry.
(5) Not Fully Mission Capable If. If vehicle meets criteria in this column, vehicle is Not Mission