Lay tire (1) flat.
Do not use runflat compressor if compressor strap is frayed or damaged.
Inspect tools pivot points and bearings and ensure runflat is free of
grease and runflat compressor strap is centered around runflat. Failure
to do so could cause injury to personnel.
Any oil on runflat compressor belt or handle could result in personnel
injury or damage to equipment. Wipe any oil off from belt or handle.
Perform steps 11 and 12 when using runflat compressor P/N J39250.
Perform steps 13 and 14 when using runflat compressor P/N 528236.
Make sure gear and pivot points on runflat compressor (6) or (3) have a light coat of oil to ensure
ease of operation and protect from rust.
Position runflat compressor (3) on runflat (2) so that runflat compressor hex drive (4) is facing up
and strap (5) is centered around runflat (2).
Compress runflat by rotating hex drive in either direction. Rotate hex
drive opposite to loosen.
Using runflat compressor (3), compress runflat (2).
Position runflat compressor (6) on an outer edge of runflat (2) with handle assembly (7) facing up
and strap (8) centered around runflat (2).
Compress runflat by rotating the handle assembly in a clockwise
direction. Rotate handle assembly counterclockwise to loosen.
Using runflat compressor (6), compress runflat (2).
It may be necessary to use a tire spoon and tire soap to remove
runflat from tire.
When using runflat compressor P/N 528236, handle may need to be
removed before removing runflat.
Remove runflat (2) from tire (1) and remove runflat compressor (3) or (6) from runflat (2).
RUNFLAT COMPRESSOR (P/N J39250)
RUNFLAT COMPRESSOR (P/N 528236)
8-5.1. RADIAL TIRE, WHEEL, AND RUBBER RUNFLAT MAINTENANCE (M1123 AND
A2 VEHICLES) (Contd)