TM 9-2320-280-20-2
4-126. HEAT/VENT CONTROL PANEL, RELAY AND SWITCH MAINTENANCE
(M996, M996A1) (Contd)
o. Rollover Switch Removal
1. Disconnect rollover switch lead (7) from harness lead (8).
2. Remove screw (4) and lockwasher (3) from two terminals (2) and heater RUN-START switch (5) and
remove rollover switch (1). Discard lockwasher (3).
p. Rollover Switch Installation
1. Install two terminals (2) on heater RUN-START switch (5) with lockwasher (3) and screw (4).
2. Connect harness lead (8) to rollover switch lead (7) and snap in rollover switch (1) in switch
bracket (6).
FOLLOW-ON TASKS: Install heat/vent control panel (para. 4-125).
Install heater compartment panel (para. 11-204).
Connect battery ground cable (para. 4-73).
4-318